Surface Waterproofing-Watercut

Watercut is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent, rapid setting mortar which is easy to apply in many difficult conditions. The material is based on a blend of cements, graded aggregates, special fillers and chemical additives which control the rate of set and minimize the risk of thermal cracking. Watercut provides an initial set time of approximately one minute

Emergency water-stopping capability
 Single component
 only requires addition of clean water
 Excellent bond to the substrate
Low exotherm minimizes thermal cracking
 Pre-bagged formulation to overcome variations in site batching
 Contains no chloride admixtures

For the rapid temporary patching and plugging of concrete segments, concrete & brick tunnel linings, sewage systems, below ground access chambers, pipes, basements, foundations and mines


Appearance Gray Cementitious Powder
Initial set time Approx. 3 minute @ 20°C

 Watercut is available in 25 kg bags
 Watercut has a minimum shelf life of 6 months at 35°C if kept in a dry store in the original, unopened packs. The shelf life will be reduced at higher ambient temperatures